How To Reset Bios Without Display?

I'm sure you've struggled with this problem. You probably just want to restore your system to the manufacturer's settings and start fresh, but then you realize you need to reset bios without display and your computer doesn't have any built-in features for this

The BIOS, which is short for Basic Input/Output System is the ROM chip that can be found on motherboards. It allows you to set up and access your computer.

It includes instructions on how to load the computer’s hardware to ensure it boots properly. 

Since it’s an important component, modifying and resetting it should be done properly. If you make a mistake, it can ruin your computer. In worst-case scenarios, the damage can be irreversible.

What does BIOS do?

Apart from being the core for operations, the BIOS configures hardware settings like computer passwords, time, and date. It is also responsible for locating the operating system. In addition, it can test hardware and looks for errors before starting the operating system.

How can you access BIOS?

BIOS can be accessed through the BIOS screen during startup or from the Command Prompt. If you’re accessing it during startup, it should display what version it is.

However, there will be times you’ll be needing to reset the BIOS. This helps reset it to the factory settings if you made a few tweaks to it. It can also restore it to the latest configuration that you saved so that your system can revert to its state before any changes were made.

There are times when the BIOS display won’t show up during boot. Here’s what you can do about it. 

How to Reset without Display

If you can’t access your BIOS through your computer, you’ll need to manually reset it. This should be on every type of motherboard. 

Steps:

1. Turn the power supply off. Make sure there’s nothing connected to the electrical socket. 
2. Make sure that all power is gone. You can wait from 30 seconds to 5 minutes.
3. Next, you need to remove the CMOS battery. It looks like a battery button. Remember, there should be no power cords attached. If you’re not sure what it looks like, check your model specifications first before removing any parts.If your CMOS battery is damaged, it might be best to replace it with a new one rather than putting back the old battery in the motherboard later.Be very careful when removing the battery. Do it slowly so it doesn’t get damaged. 
4. On the motherboard, look for the BIOS Reset. It’s a set with 3 pins. Generally, all you need to do is move two jumper cables from two pins to the other two pins. Wait for 10 seconds. If it looks different, check the manual of your device first. Just go to the manufacturer’s website. It should be available there.
5. After 10 seconds, move the 2 pins back to their original position. If your device’s manual has a different instruction, it’s best to follow that.
6. Put the battery back to its position.
7. Once everything is set back to its original placement, turn it on. This should be able to reset your BIOS. Remember that it will set everything back to the factory settings. 
8. As soon as it turns on, go to the BIOS Setup. You can choose between Optimized Default set or Load the factory Default. Whichever you choose, press Save and Exist so that it can finish booting.
9. You will also need to need to reset your previous custom settings afterwards.

Final Words

If your BIOS doesn’t display, don’t panic right away. There are some configurations that you can do to keep it up and running. However, you likely have to reset everything. If the steps mentioned above did not work for you, it’s best to either contact the manufacturer’s support team or seek professional help.

Summary: Reset bios without display

1. Open your computer case.
2. Locate your BIOS battery.
3. Remove the battery from the motherboard.
4. Carefully set the battery aside and wait.
5. Put your battery back in place.
6. Close up your case and power on your PC.